Construct your Airtrack setup !
Construct your Airtrack setup !
Construction of the air table
Airtable part 1: Precut of the aluminium profile strut
Airtable part 2: Predrill
Airtable part 3: Glueing and screwing
Airtable part 4: Construction of the framework
Airtable part 5: Insertion of ball valves
Airtable part 6: Incoming air and pressure control
Construction of the peripherals
Peripherals part 1: Attaching the camera
Peripherals part 2: Construction of the linear actuator front
Peripherals part 3: Construction of the rewarding system
Peripherals part 4: Construction of the head fixation
Peripherals part 5: Floating platform
Set up of the electronics
Electronics part 1: Set up of the wiring
Electronics part 2: Uploading of scripts to the Arduino Uno
Electronics part 3: Configuration of the PixyCam 2
Electronics part 4: Arduino code guide
3D print settings:
Layer height: 0.2 mm
Infill: 60 %
Support: No
Raft: if needed